Here is Apple's support article for troubleshooting a Thunderbolt connection on a Mac. check your cable to make sure it is Thunderbolt compatible.
make sure both ends of the Thunderbolt cable are fully connected to each Mac, or router or access point.More Thunderbolt Connection Troubleshooting The connection status on the left side menu panel will also change to a yellow dot and labelled as "Self-Assigned IP".
#MAC ETHERNET CONNECTION NOT PRIVATE MAC#
Once your primary Mac detects that it is connected to your secondary Mac, an IP Address will be shown in the IP Address section. In the left side menu, select Thunderbolt Bridge and ensure that Configure IPv4 is set to "Using DHCP". On your primary Mac, open Network Preferences by going to System Preferences > Network, or by clicking on the Wi-Fi symbol in your menu bar and selecting "Open Network Preferences". Make sure you are using a Thunderbolt cable, as regular USB-C to USB-C cables (like the Mac's charging cable) will not work. Troubleshooting the Thunderbolt ConnectionĪ Thunderbolt bridge needs to be established between your Macs before Luna can connect using a Thunderbolt connection. Here is Apple's support article for troubleshooting an Ethernet connection on a Mac. create or switch to a new network location on your Mac.restart your Macs, or restart your router or modem.make sure both ends of the Ethernet cable are fully connected to each Mac, or router or access point.If your devices are connected via Ethernet, the Status will change to Connected and the left side menu panel will either say "Connected" or "Self-Assigned IP" under the USB/LAN option. On your primary Mac, open Network Preferences by going to System Preferences > Network, or by clicking on the Wi-Fi symbol in your Mac's top menu bar and selecting "Open Network Preferences".
In the Mac-to-Mac tab, change "Allow any network interface" to your preferred connection method: Connect via Wi-Fi only, Connect via Ethernet only, or Connect via Thunderbolt only. In your Mac's top menu bar, click on Luna Display then Preferences. You can also adjust Luna's settings so that Luna will only connect over an Ethernet or a Thunderbolt connection, instead of Wi-Fi. Luna should connect automatically if it detects an active Ethernet or Thunderbolt connection between your Macs. Please give me a change to reach out internally.Why is my Ethernet or Thunderbolt connection not working? Mac-to-Mac Mode: Connect via Ethernet or Thunderbolt Only If you have another network adapter that uses the same range, you will need to either modify the sample or disable the other network adapter temporarily. Note: The samples uses the IP address range. Note: If your computer is managed by policies that prevent it from being connected to multiple network interfaces at once, you may need to disable other network interfaces while using this sample. If using an Ethernet private network, attach an Ethernet cable from the Ethernet adapter on the device to the Ethernet connection on your computer. Connect your computer to the private networkĬonnect your computer to the same private network to which you connected your device. You might already be using this sample application but wanted to make The sample application accomplishes a similiar design through the use of netwrok services. I am going to need to speak with the product group directly to ask about ethernet use cases. Example application, it walks you through the process ofĮnabling the ethernet interface but I am not sure that there is a means to expose the MAC address, as there is a means to do so with the WiFi interface but, in viewing the generated logs in Visual Stuido.there is a possibility that the MAC address is
0 kommentar(er)
